Used Commercial Gas Ranges: Vulcan 36S-6B, Southbend S36D, Garland X60

What Vulcan, Southbend, Garland and the CPSC say about pilots, thermocouples and the 2006 Robertshaw recall on used gas ranges, and the price and repair figures we removed.

Updated: 2026-10-26

A used gas range that will not stay lit is a range that does not work, and the manufacturers' own documents explain why. A pilot flame heats a sensor, the sensor holds a gas valve open, and if the flame or the sensor weakens, the valve closes. This page covers three ranges. The Vulcan 36S-6B and the Southbend S36D are 36 inch six-burner ranges with a standard oven. The Garland X60 is a different size: Garland's page for the family is titled "SunFire X60-10 X-Series 60” Open Burner Range". If you are shopping a 36 inch slot, the X60 is not a competitor.

What each maker says about the machine

  • Vulcan 36S-6B. Vulcan's sell sheet lists "Six open top burners, each burner is 30,000 BTU/hr. with lift-off burner heads", a "Shrouded flash tube pilot system (one pilot per two burners)" and a "35,000 BTU/hr. baker's depth standard oven cavity; full size sheet pans fit side-to-side or front-to-back".
  • Southbend S36D. Southbend's spec sheet lists "six (6) 28,000 BTU NAT (24,000 BTU LP) PATENTED, one-piece cast iron, non-clog burners with Lifetime Warranty." and an oven "Equipped with flame failure safety device".
  • Garland X60. A 60 inch range, as above. We have no used data and no verified recall data for it.

The recall, and where the brands differ

The CPSC notice for the 2006 Robertshaw recall says "The recalled controls can remain on after the pilot light is extinguished." It splits into two parts with two brand lists.

  • Flame switches: "Keating (of Chicago), PMI Food Equipment Group, Vulcan, Southbend, Blodgett, Toastmaster, and Wolf Range."
  • Automatic safety valves: "Bari (Restaurant and Pizzeria), Southbend, and Blodgett."

Read them against each other. Vulcan is on the switch list only. Southbend is on both, so a Southbend from the affected period has two controls to rule out. Garland is on neither list. The sale windows were "from August 2005 through June 2006 for the FS Flame Switches and from April 2006 through June 2006 for FM Automatic Valves".

The CPSC notice does not list ranges by model, but it says "For a list of appliances with recalled switches and valves, visit www.robertshaw.com." We have not retrieved that list. Read the ID plate, then check it. A range from the affected period with no record of a control replacement should not be bought until someone has checked.

The pilot is the thing to test

Garland's gas controls reference explains the mechanism in plain terms. "The thermocouple is two dissimilar metals, which form a junction, and when they are heated, they create a millivoltage." It adds that "If there is no heat at the thermocouple, the valve will not stay open." and puts the output at "The small amount of electricity produced is 20 to 30 millivolts." So a pilot that drops out can be a weak flame, a dirty or misplaced sensor, or a valve that is not holding. These are different repairs, and a seller who says the range "just needs a new gas valve" has not necessarily tested the cheaper parts first.

Southbend's owner's manual gives a test sequence for the oven pilot. It says "Continue to hold the button for 30 seconds. The pilot should remain lit after the button is released." If it does not, the manual has you test the thermopile at the safety valve with a multimeter, where "If the voltage does not rise above 450 millivolts, then adjust or clean the pilot assembly to chieve a larger flame." That is the manual's wording, typo included. The figure is for Southbend's thermopile oven pilot. It is not a threshold for every range, so use the number in the manual for the model in front of you. We previously printed a different, lower figure for a thermocouple. We could not source it and removed it.

What we removed

We removed every price: new street prices, the used Southbend band, and the Garland X60 part list with its percentages. We removed the thermocouple and service call ranges, the expected-life figure and the replace-every-few-years rule, because none appears in a manufacturer or CPSC document. The old page also claimed the CPSC notice names no models. It points to a Robertshaw list, as above.

At inspection

  1. Read the ID plate. Note the model, serial number and date, and check them against the Robertshaw list.
  2. Light every pilot and the oven pilot, and hold the button as the manual says. Watch whether each stays lit.
  3. Ask for any record of pilot or valve work.
  4. Get a dealer quote for the pilot assembly on that exact model before you set your price.

Sources

Every quotation above was fetched from the document linked here and matched word for word on 2026-10-26.